Bennett-marine Auto Tab Control Manual de usuario

AUTO TAB CONTROL (ATC)OWNER’S MANUAL & INSTALLATION INSTRUCTIONSIMPORTANT: This manual contains critical information directly affecting the safe

Step 5: Connecting the Trim Tab Wire Harness to the ATC Control UnitCut the terminals off the ends of the • existing 4-color Trim Tab Wire Harness.St

Installation Instructions for Electronic Indicator Control (EIC5000) Systems IMPORTANT: If you did not purchase the Auto Tab Control set designed fo

Description Part #1 ATC Keypad AC32502 ATC 6' Keypad Cable AC325063 ATC Control Unit AC34004 ATC

System Schematic and Parts List for Bennett Electronic Indicator Control System≈Electronic Indicator Control(Existing)Existing Port Sensor Wire (Red

If you have any questions regarding the installation of the Bennett Auto Tab Control, please contact us at Bennett Marine, Inc550 Jim Moran Blvd.Deer

15$7&.(<3$'02817,1*7(03/$7(

ATC20P-ATC-X

Congratulations! You are the owner of the most sophisticated Trim Tab control system in the world. Nothing will create a more efciently trimmed boat

SECTION 2BEFORE INSTALLING THE AUTO TAB CONTROL, YOU MUST CHECK THE TRIM TAB SYSTEM INSTALLATIONThe ATC system interfaces with the boat’s trim tab sys

For Boat Leveler Insta-Trim SystemsThe Auto Tab Control installation instructions are based on Bennett Trim Tab wire colors. If you are installing the

Turning the ATC on. Once you’ve set the Zero Point you can now press the ON/OFF button for 2-3 seconds to turn your ATC on. It will now take control

SECTION 4ACTIVATING AND DEACTIVATING THE AUTO TAB CONTROLThe ATC system is activated by pressing the ON/OFF button for 2-3 seconds. When the button i

BE PRUDENT — IF IT APPEARS THE ATC SYSTEM IS CAUSING YOUR BOAT TO REACT IN AN UNDESIRABLE MANNER, STOP THE BOAT – THEN INVESTIGATE THE PROBLEM.Trim t

AUTO TAB CONTROL (ATC)INSTALLATION INSTRUCTIONSIMPORTANT: Plan how you will lay out the system. Consider the wire runs from the Keypad to the Contro

Step 2: Mounting the ATC KeypadCut out the template from the last page of this manual.• Tape the template to the dash where you intend to mount the Ke